Hell if you were close I’d sell you mine. Unless you get one from someone for next to nothing, then by all means try it out. I would say not to waste the money buying a second WB with windage and elevation adjustments like I did and pick up a drop away directly. I now have a rest that costs more than a quarter of the price of the bow, but it shoots great. I’m shooting a cheap single cam bow that’s not well known for straight nock travel either…that may be a contributing factor. The better of the bow techs mentioned that he’s seen WB’s be difficult to tune on some bows. I also suspect that the biscuit’s full containment bristles also contact the shaft enough to have an effect on the natural dynamic spine of the arrow and can make it leave the bow unpredictability. I fully believe that a drop away is not inherently more accurate, but that it IS more forgiving to shoot as it’s contact with the shaft, and therefore the time in which you have to negatively impact the shot, is less. I love the full containment (better than QAD), but here’s the rub: the whisker biscuit makes contact with the shaft the entire time until the mock clears the biscuit. Fundamental fail-safe rest sought-out by bow hunters of all skill-levels Large mount design for use with right-handed bows Make easy corrections with. I do not believe that the whisker biscuit is a bad rest. If you have a fall-away rest, connect the rest cord to the downward buss cable or to a limb, again, following the. They are an awesome all-around hunting rest, especially for whitetail hunters taking shots at deer inside of 40 yards. Took the setup home and made some minute adjustments with broadhead tipped arrows and was satisfied in about an hour of tuning. If you have a whisker biscuit or hostage-type rest, you’re done for now. You can put your arrow in that rest and you don’t have to worry about it falling off as you're moving the bow around and up and down, crawling around on game. Keep in mind two different shops had been asked to look at the biscuit setup and make sure it was all square. Tech had it on and shooting a bullet hole in 20 minutes. Got the shits of it and had the shop install a QAD HDX. It just would not fling arrows straight with the WB, broadhead or bare shaft. Bought an adjustable whisker biscuit rest and had it installed, continued to have issues getting fixed heads the fly well. Thus, you can put a whisker biscuit on recurve bows with sight and cut-out risers for best results. Was trying to tune broadheads and having a bear of time doing it. Whisker biscuit is the most famous type of arrow rest among target archers and hunters. That lowers the impact that the drop-away rest has on the accuracy and. On the other hand, the drop-away arrow rest, because of the design and adjustment, only gets 25 to 50 percent contact with the arrow. Here’s my take on this as I experienced a similar situation with my Bear and cheapo biscuit. The issue with the whisker biscuit is that the whiskers will slow down the arrowsnot much, but you lose about 3 to 6 fps on your shots.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |